Garage torsion springs are a critical component of your garage door system. These springs provide the necessary tension to counterbalance the weight of the door, making it easier to open and close. Over time, torsion springs can wear out or break, necessitating replacement. While it’s recommended to hire a professional for this task, if you have the necessary skills and tools, you can install garage torsion springs safely by following this step-by-step guide.
Safety First
Before you begin the installation process, prioritize safety. Put on protective gear such as safety glasses and gloves to shield yourself from potential hazards. Also, ensure that anyone around the area is aware of the work being done and stays clear.
Gather the Required Tools and Materials
To install garage torsion springs, you’ll need the following tools and materials:
Replacement torsion springs (make sure they are the correct size and have the appropriate wire size and winding direction)
Winding bars (two sturdy steel rods)
Adjustable wrench
Socket set
C-clamps
Stepladder
Safety cable (optional but recommended for added security)
Release the Tension on the Existing Springs
To begin, it’s crucial to release the tension on the existing springs to ensure a safe removal. Using winding bars, carefully unwind the tension from each spring. Follow the manufacturer’s instructions for the specific type of spring you are working with.
Remove the Old Springs
Once the tension has been released, use an adjustable wrench or a socket set to loosen and remove the set screws that secure the springs to the torsion tube. Take note of the number of turns required to unwind the springs fully as this will be important during installation.
Install the New Springs
Position the new springs onto the torsion tube, ensuring they are properly aligned. Insert the set screws and tighten them securely. Make sure the springs are evenly spaced and centered on the tube.
Wind the Torsion Springs
Using the winding bars, carefully wind the torsion springs, following the correct winding direction specified by the manufacturer. It’s crucial to wind the springs to the appropriate number of turns as noted in Step 4. Take your time and ensure the winding is even on both sides.
Secure the Springs
Once the springs are properly wound, secure them in place by tightening the set screws. Double-check that everything is securely fastened and aligned.
Test the Door Functionality
Before completing the installation process, verify that the door operates smoothly. Open and close the garage door a few times to ensure it moves correctly and there are no issues with the spring tension.
Optional: Install Safety Cables
For added safety, consider installing safety cables. These cables run through the center of the springs and prevent them from becoming projectiles in case of spring failure. Attach one end of the safety cable to the wall or ceiling near the torsion springs and the other end to the bottom of the spring anchor bracket.
Perform Regular Maintenance
After installing the garage torsion springs, it’s essential to perform regular maintenance. Lubricate the springs and other moving parts of the garage door system periodically to ensure smooth operation and prolong the lifespan of the springs.
By following this step-by-step guide, you can safely install garage torsion springs. However, keep in mind that working with torsion springs can be dangerous, and it’s always advisable to consult a professional if you’re uncertain or uncomfortable with the process. Proper installation of garage torsion springs is crucial for the safe and efficient operation of your garage door, providing you with peace of mind and convenience.
English (United States) 
English (Canada) 
Spanish (Peru) 
Spanish (Mexico) 
German 
Russian 
French